Free · no account · STL, STEP, OBJ
Wall hook generator
Give the height, the arm length and the screw hole. The generator builds a hook with a rounded tip in your browser and exports it ready to print.
Builds in your browser. The CAD engine downloads once (about 60 MB), then every part is local.
What to put in the prompt
- Give the overall height, the width and the thickness. 6mm thick carries a coat; 10mm carries a bike.
- Give the arm length and say rounded tip or upturned lip so things do not slide off.
- Give the screw hole size and count. Say countersunk for flat-head screws.
- Say where it mounts: wall, desk edge, shelf, 2020 extrusion. Edge clamps need the edge thickness.
More on prompts: writing effective prompts.
Made with this generator
Real builds from the gallery. Open one to see the six-view render and the exact prompt, then build it or change a size.
Frequently asked questions
How much weight can a printed hook hold?
A 6mm thick PLA or PETG hook with two screws holds a coat or a bag easily. For heavier loads go to 8 to 10mm and print the hook lying on its side so the layers run along the arm.
Can it make command-strip or adhesive hooks?
Yes. Ask for a flat back with no holes and the strip size, for example a 40mm x 20mm flat back for an adhesive strip.
Guides for this part
Other generators
Spur gear generator
A 20-tooth spur gear, module 2, 8mm thick, with a 6mm bore
Mounting bracket generator
An L-bracket 50mm x 50mm, 30mm wide, 4mm thick, with two 5mm holes in each leg
Electronics enclosure generator
An enclosure with an inside size of 80mm x 50mm x 30mm, 2mm walls, and four M3 standoffs on a 75mm x 45mm pattern
Threaded bolt and nut generator
An M8 x 50 hex head bolt with a 13mm hex head, 5mm tall
Washer, spacer and bushing generator
A washer with an 8.4mm hole, 16mm outer diameter, 1.6mm thick
Pipe, hose and duct adapter generator
A hose adapter from 32mm outer diameter to 25mm outer diameter, each end 30mm long, 2mm walls
3D-printable keychain maker
Olivia